The zen discovery is the built in discovery module for elasticsearch and the default. It provides both multicast and unicast discovery as well being easily extended to support cloud environments.
The zen discovery is integrated with other modules, for example, all communication between nodes is done using the transport module.
It is separated into several sub modules, which are explained below:
This is the process where a node uses the discovery mechanisms to find other nodes. There is support for both multicast and unicast based discovery (can be used in conjunction as well).
Multicast ping discovery of other nodes is done by sending one or more multicast requests where existing nodes that exists will receive and respond to. It provides the following settings with the discovery.zen.ping.multicast prefix:
| Setting | Description |
|---|---|
| group | The group address to use. Defaults to 224.2.2.4. |
| port | The port to use. Defaults to 54328. |
| ttl | The ttl of the multicast message. Defaults to 3. |
| address | The address to bind to, defaults to null which means it will bind to all available network interfaces. |
Multicast can be disabled by setting multicast.enabled to false.
The unicast discovery allows to perform the discovery when multicast is not enabled. It basically requires a list of hosts to use that will act as gossip routers. It provides the following settings with the discovery.zen.ping.unicast prefix:
| Setting | Description |
|---|---|
| hosts | Either an array setting or a comma delimited setting. Each value is either in the form of host:port, or in the form of host[port1-port2]. |
The unicast discovery uses the transport module to perform the discovery.
As part of the initial ping process a master of the cluster is either elected or joined to. This is done automatically. The discovery.zen.ping_timeout (which defaults to 3s) allows to configure the election to handle cases of slow or congested networks (higher values assure less chance of failure). Note, this setting was changed from 0.15.1 onwards, prior it was called discovery.zen.initial_ping_timeout.
Nodes can be excluded from becoming a master by setting zen.master to false. Note, once a node is a client node (node.client set to true), it will not be allowed to become a master (zen.master is automatically set to false).
There are two fault detection processes running. The first is by the master, to ping all the other nodes in the cluster and verify that they are alive. And on the other end, each node pings to master to verify if its still alive or an election process needs to be initiated.
The following settings control the fault detection process using the discovery.zen.fd prefix:
| Setting | Description |
|---|---|
| ping_interval | How often a node gets pinged. Defaults to 1s. |
| ping_timeout | How long to wait for a ping response, defaults to 30s. |
| ping_retries | How many ping failures / timeouts cause a node to be considered failed. Defaults to 3. |