Op-Amps : Non-Inverting configuration

Make the Connections as shown in the figure.
CH1 monitors the original waveform output from W1.
CH2 monitors the amplifier output .

Observe various gains by changing Rf/Ri Ratio.
If gain is greater than 2x , reduce the input waveform amplitude by turning the amplitude knob next to W1 so that the output voltage does not exceed limits.

Enter Resistance values in the following boxes and click to calculate the theoretical gain

Rf:
Ri:

Gain:

Enter Resistance values in the following boxes and click to calculate the theoretical gain if a capacitor is added in parallel to Rf

Feedback(Rf):
Input (Ri) :
Capacitance:
Frequency :

Gain: